Charging The Ht5F1700B Battery - FUTABA 1M23N20718 Instruction Manual

Charging The HT5F1700B Battery

Charging
1
Plug the transmitter cord of the special char-
transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
When charging the HT5F1700B battery with the special char-
ger, allow about 15 hours for charging. If the transmitter has
not been used for some time, cycle the battery by charging
and discharging it two or three times.
Warning
Never plug it into an outlet of other than the indicated voltage.
Do not insert and remove the charger when your hands are wet.
It may cause an electric shock.
Always use the special charger or a quick charger for digital proportional R/C sets to charge a
digital proportional R/C set Ni-MH battery.
lyte leakage.
Caution
Never try to recharge a dry cell battery.
The transmitter may be damaged or the battery electrolyte may leak or the battery may break.
When the charger is not in use, disconnect it from the AC outlet.
Do this to prevent accidents and to avoid overheating.
20
To receiver
Ni-Cd battery
When using Futaba CR-2000
T h e H T 5 F 1 7 0 0 B i s 5 - c e l l s , s o , w h e n c h a rg i n g t h e
HT5F1700B battery with Futaba CR-2000 charger, you have
to use the RX output side.
Charging
jack
Over current protection
The transmitter charging circuit is equipped with an over cur-
Cover
rent protection circuit (1.7A). If the battery is charged with a
quick charger for other than digital proportional R/C sets, it
may not be fully charged.
AC outlet
Charger
Transmitter charging
LED
To transmitter
charging jack
-