Table of Contents
Advertisement
Models 8084/8084AD/8085 Closed Caption Encoder Manual
3.1.1
Navigating the Front Panel Menus -- The Setup Group
The menu systems use the 16 digit alphanumeric display and the Setup
key group (SELECT, SETUP,
) to configure the closed caption
encoder.
There are two menu systems used to configure the closed caption encoder.
Users will most often use the Setup menu, which is accessed by pressing
the SETUP key. The Setup menu is used to configure the basic operation
of the Closed Caption Encoder. There is also an Engineering menu, which
contains items not normally required during normal operation. To enter the
Engineering menu press the SHIFT + SETUP keys.
To navigate within the menu system, press the
or
keys to move to the
next menu item. When you have chosen the desired menu item, press the
or
keys to view the options available for that menu item.
The
currently selected setting will be flashing. When you have chosen the
desired setting for the menu item, press the SELECT key to save that
value.
The currently active menu setting will be flashing.
When you have made all the desired changes, press the SETUP key to exit
the menu system and return to the normal display mode.
The display will automatically return to the normal display mode if no key
presses are made for several seconds. (See section 3.1.4)
The menu systems consist of a main menu with two or more choices for
each menu item. A ")" symbol is shown to the left of the main level Setup
menu items. A ">" symbol is shown to the left of the main level
Engineering menu items. This allows them to be easily distinguished from
each other and from the front panel operating messages. The sub-menu
choices are shown in lower case to allow them to be easily distinguished
from the main level items.
Figure 3-5 is an overview of the Setup menu system that shows all of the
menu items and where you will find the menu choices. Figure 3-6 is an
overview of the Engineering menu system that shows all of the Engineering
menu items and where you will find the menu choices. In each figure,
factory default choices for each menu item are shown in boldface.
Each of the Setup menu items is described in section 3.2 with an
explanation of what each choice does. Each of the Engineering menu
items are described in section 3.3 with an explanation of what each choice
OPERATION
Page 3-2
Revision 1.6.6
Advertisement
Table of Contents
