Install Equipment Covers; Access The Electrical Enclosure; Install The Adm Screen - Graco InvisiPac HM10 Instructions Manual

Install Equipment Covers

Refer to F . 68.
IG
1. Tighten the fasteners to install the rear melter cover
(224).
2. Connect the air lines to the triple union fitting (236).
3. Install the air filter (60).
4. Tighten the fasteners to install the front melter
cover (10).

Access the Electrical Enclosure

DANGER
SEVERE ELECTRIC SHOCK HAZARD
This equipment can be powered by more than 240V.
Contact with this voltage will cause death or serious
injury.
• Turn off and disconnect all power before
disconnecting any cables and before accessing
the electrical enclosure.
1. Follow the Pressure Relief Procedure, page 26.
2. Press the power button on the ADM screen to shut
down the system.
3. Disconnect power from the equipment.
4. Loosen the ADM fasteners (9) to separate the ADM
(6) screen from the equipment.
5. On 2 channel units, disconnect the bulkhead USB
cable from the right angle USB cable (67). On 4
channel units, disconnect the bulkhead USB cable
from the USB hub (73).
6. Disconnect the CAN cable from the back of the
ADM.
7. Remove the ADM screen (6) to access the electrical
components inside the enclosure.
3A7259C
9
6
F . 69: Electrical Enclosure Access
IG

Install the ADM Screen

Refer to F . 69.
IG
1. Prepare Equipment for Service. Follow the steps
on page 82.
2. On 2 channel units, insert the bulkhead USB cable
into the right angle USB cable (67). On 4 channel
units, insert the bulkhead USB cable into the USB
hub (73).
3. Connect the CAN cable between the AMZ circuit
board and ADM screen.
4. Install the ADM screen (6) to the equipment with the
ADM fasteners (9).
Repair
83