Setup Screens - Graco InvisiPac HM10 Instructions Manual

Setup Screens

Set system and component settings. See Set Baseline
ADM Settings, page 19 for basic configurations and
instructions.
Gun Setup
Install heat channels and select gun RTD type. See
Setup Applicators on the Gun Setup Screen, page 19
for screen details.
General
See Set System Settings in the General Settings,
page 19 for screen details.
PLC I/O
Configure and view the current state of the system PLC
inputs and outputs. See Set PLC Settings on the
ADM, page 25 for screen details.
3A7259C
Material Tracking
F . 43: Material Tracking Screen Capture
IG
Name Description
Enable AUX unit Check to enable the AUX unit
counter counter on the System I/O Board.
See Setup section for AUX Unit
Counter wiring details.
Enable material Check to enable material alerts
alerts when the current material unit
deviates 20% from the established
target.
Specific gravity Specific gravity of the material in
use.
Target weight The system automatically learns the
per unit target usage after running for several
minutes.
TR Button Press the TR Reset button to reset
and relearn the target usage.
Weight per unit Current weight per unit.
Calibration Resettable totalizer that can be used
Weight Totalizer for determining Specific Gravity.
Reset Weight Press the button (RW) to reset the
Totalizer (RW) calibration weight totalizer.
ADM Screens
TR
RW
43