Table of Contents
Advertisement
Repair Kits
4 Channel Upgrade Kit 20B918
Upgrade HM10 2-channel systems to a 4-channel
system.
F
. 117: 2 Channel ADM Connections
IG
73
F
. 118: 4 Channel ADM Connections
IG
134
75
Ref.
Description
73
Hub, USB, 4 Port
75
Flash Drive, 4 Channel Upgrade
1601 Double-Sided Tape
Channel Upgrade Instructions
67
DANGER
SEVERE ELECTRIC SHOCK HAZARD
This equipment can be powered by more than 240V.
Contact with this voltage will cause death or serious
injury.
•
Turn off and disconnect all power before servicing
electrical components.
308
1. Turn the main power switch (204) OFF and
disconnect power from the system.
2. Access the Electrical Enclosure, page 83.
3. Attach the 4 port USB hub (73) to the back of the
ADM in the location shown in F
included double-sided tape.
4. Connect the right angle USB connector (67) to the
USB hub cord (73).
67
5. Plug the 4 channel upgrade flash drive (75) into the
USB hub (73).
6. Plug the USB bulkhead cable into the USB hub
(73).
7. Install the ADM Screen, page 83.
8. Reconnect power to the system and turn the main
power switch (204) ON.
9. Verify Four CH license present and Four CH
308
unlocked are both green on the I/O tab of the
diagnostic screen.
Qty.
1
1
1
. 118, using the
IG
3A7259C
Advertisement
Table of Contents
Troubleshooting
