System Requirements - Graco InvisiPac HM10 Instructions Manual

Installation

System Requirements

Power Requirements
To help prevent fire and explosion, a qualified
electrician must determine the proper circuit breaker
size to use for the power supplied to the system.
The system requires a dedicated circuit protected with
a circuit breaker in each ungrounded phase. See F
Main Power Switch Wiring on page 18 for details.
Follow all national, state, and local electrical codes and
regulations.
Heated Hose Requirements
All heated hoses attached to the system must be rated
for 1200 psi (8.3 MPa, 83 bar), 400°F (204°C), have an
RTD type sensor, and use no more than 1250W at 240
VAC. Non-Graco heated hoses require an electrical
adapter cable.
Applicator Requirements
All applicators attached to the system must be rated for
1200 psi (8.3 MPa, 83 bar), 400°F (204°C), have an RTD
type sensor, and use no more than 400W at 240 VAC.
Non-Graco applicators require an electrical adapter
cable.
12
Air Line Requirements
If using the same air for actuating the applicator(s),
install the tee in the air supply line before connecting
the main air line to the system. See your applicator
manual for applicator air pressure requirements. If
necessary, use an applicator air regulator before the
applicator to decrease air pressure.
• Main air line (CC): 3/8 in. (9.5 mm) minimum air
supply line. 1/2 in. (12.7 mm) required for lines more
than 50 ft (15.2 m).
For best performance, supply pressure should be
. 7:
IG
between 80 psi (550 MPa, 5.5 bar) and 100 psi (690
MPa, 6.9 bar). If air supply is not able to sustain
pressure at the flow rate required by the InvisiPac
system, or if pressure is expected to drop due to
other equipment sharing the supply, an Air
Reservoir Kit 16W366 is available that allows the
system to operate on lower pressure or restricted
air supply lines.
30 scfm capacity.
• Applicator air regulator: Set to 70 psi (4.8 bar,
0.48 MPa). Not supplied with system. Purchase
separately.
3A7259C