Setup Adhesive Supply - Graco InvisiPac HM10 Instructions Manual

Setup Adhesive Supply

Remote Vacuum Feed Models: Connect
Feed System
1. Refer to the feed system manual to install the feed
system. See Compatible Drum Vacuum Feed
Systems, page 3.
2. Adjust the funnel inlet if desired.
a. Loosen the funnel fasteners (231) to adjust the
funnel inlet.
b. Rotate the funnel inlet (229) to the desired
position.
c. Tighten the fasteners (231) to secure the funnel
inlet position.
229
F . 2: Funnel Inlet Adjustment
IG
3. Connect the feed hose to the funnel inlet (229).
a. Insert a 1.3 in. (33 mm) OD clear feed hose into
the funnel inlet (229).
b. Tighten the hose clamp over the cutouts in the
funnel inlet to secure the feed hose.
3A7259C
231
F . 3: Feed Hose Connection
IG
4. Connect the feed system 3/8 in. (9.525 cm) OD air
supply hose to the system.
On-Board Hopper Models: Add Adhesive
Pellets to the Hopper
1. Open the hopper lid.
2. Pour adhesive pellets into the hopper.
Installation
13