Table of Contents
Advertisement
Maintenance
F
. 28
IG
8. Allow hot melt cleaning fluid to soak in the melter
for the duration specified by the cleaning fluid
manufacturer.
9. Disconnect all hoses from the applicator manifolds
and route into a waste container.
10. Open the bleed-type air valve (62) and slowly
increase pressure to purge into the waste
container.
11. After flushing, set the refill setting to Hopper or Bin
Auto. See page Set Baseline ADM Settings,
page 19.
12. Perform Initial Startup and Prime Procedure,
page 26. Maintain the manufacturers
recommended temperature settings until the
system is primed with adhesive.
Inspection Schedule
Task
Inspect Funnel Filter
Replace Pump Outlet Filter
Replace Pump Inlet Filter
32
Maintenance Interval
6-12 months
50,000 lb (25,000 kg) of
adhesive pumped
As needed
Funnel Maintenance
Inspect the Funnel Cover and Funnel Filter
Inspect and clean the funnel and funnel filter to ensure
clear melter air and pellet flow. The funnel cover and
filter and can be inspected without interrupting
production.
•
Remove, inspect, and clean the funnel cover.
•
Replace or clean the filter as needed.
•
Remove adhesive, pellets, or buildup in the funnel.
F
. 29: Funnel Cover and Funnel Filter Assembly
IG
3A7259C
Advertisement
Table of Contents
Troubleshooting
