Table of Contents
Advertisement
Refill Mode Selection: Refill modes are selected using an enumeration and a strobe bit, as shown below.
F
. 53
IG
NOTE: HM25c and HM10 have different enumeration values. Hopper Auto uses a shorter pulse duration than "Bin
Auto" or "Auto Adaptive" modes. See Set System Settings in the General Settings step 5 on page 20 for details
on what mode works best for your application.
Changing Specific Gravity: The specific gravity of the glue is used in material tracking and maintenance intervals.
Be sure to update this value when changing materials in order to maintain accurate logs.
F
. 54
IG
Updating Pump Idle Timeout: The pump idle timeout turns off the heat automatically after x minutes has passed
without detecting a change in direction on the pump. If this occurs, a bit will be set indicating the timeout occurred.
As noted below, only the time remaining until timeout is shown on the PLC input.
F
. 55
IG
3A7259C
Communications Gateway Module (CGM)
53
Advertisement
Table of Contents
Troubleshooting
