Graco InvisiPac HM10 Instructions Manual page 101

5. Set the AMZ dial position to 1.
F . 92: AMZ Dial Position
IG
6. Reconnect the cables on the inside of the electrical
enclosure to the AMZ. See Electrical Schematics,
page 105 for connections.
7. Reconnect the heated hose electrical connections
to the back AMZ.
8. Install the ADM Screen. Follow the steps on page
83
Replace Advanced Display Module (ADM)
1. Turn the main power switch (204) OFF.
2. Remove the retaining bolts above the ADM.
3. Lift and remove the ADM and panel.
4. Disconnect the USB right angle cable from the left
side of ADM.
5. On 2 channel units, disconnect the bulkhead USB
cable from the right angle USB cable (67). On 4
channel units, disconnect the bulkhead USB cable
from the USB hub (73).
6. Disconnect the M12 cable from the rear of the
ADM.
7. Remove the four retaining nuts holding the ADM to
the panel.
8. Replace the ADM and reinstall the four retaining
nuts.
9. On 4 channel units, remove the USB hub (73) with
the USB key and the right angle USB cable (67)
from the old ADM, and secure it to the back of the
new ADM.
3A7259C
10. Place the new ADM in front of the unit and connect
the M12 cable. Connect the right angle USB to the
ADM and USB bulkhead cable. For 4 channel units,
the USB hub should not be connected to anything
at this point as it cannot be used during
programming.
11. Reinstall the removable panel and retaining bolts.
12. Turn the main power switch (204) ON.
13. Plug in the USB drive containing the HM10
software into the front panel USB connection.
14. Select your preferred language from the drop
down, and press the check mark to confirm.
F . 93
IG
15. Press the check mark to confirm you will select a
.gti file.
F . 94
IG
16. Select the 20B812.gti file, and press the check
mark to confirm.
Repair
101