Set Baseline Adm Settings - Graco InvisiPac HM10 Instructions Manual

Set Baseline ADM Settings

Menu Symbol > Setup Screens
1. Turn main power switch (204) ON.
2. Select the Menu Symbol
navigation menu.
F . 9: ADM Menu Navigation
IG
3. Set the following baseline settings before
operation:
Setup Screens
- Set System Settings in the General Settings.
Follow the steps on page 19
- Setup Applicators on the Gun Setup Screen.
Follow the steps on page 19
- Set the specific Gravity on the material tracking
screen.
- See Material Tracking, page 43.
Advanced Screens
- Set or Disable a Password. Follow the steps
on page 20
- Set Material Unit
Home Screen
- Set Temperatures on the Home Screen.
Follow the steps on page 20
3A7259C
to open the
Setup Applicators on the Gun Setup Screen
1. Select the Menu Symbol
Setup.
2. Check the Installed box for each channel that has
a heated hose and an applicator installed.
3. Select the Gun RTD Type used on each installed
applicator. Refer to the applicator manual for
details on RTD type selection.
NOTE: The settings automatically save as they are
entered. Navigate to another screen after the settings
are accurately entered.
F . 10: Gun Setup Screen Capture
IG
Set System Settings in the General Settings
To help prevent fire and explosion, a qualified
electrician must determine the proper circuit breaker
size to use for the power supplied to the system.
1. Select the Menu Symbol
2. Enter Pump idle time to system inactive to allow
the system to automatically go to the Inactive state
after the desired duration of pump inactivity.
3. Select the circuit breaker size used. Use the size
of the circuit breaker used to supply power to the
system. The circuit breaker is external to the
system and provided by the user.
Installation
> Setup > Gun
> Setup > General.
19