Setup; Connect Plc Inputs - Graco InvisiPac HM10 Instructions Manual

Setup

DANGER
SEVERE ELECTRIC SHOCK HAZARD
This equipment can be powered by more than 240V.
Contact with this voltage will cause death or serious
injury.
• Turn off and disconnect all power before
disconnecting any cables and before servicing
equipment.
Follow the desired setup procedures to install
accessories and configure the system for your
application.

Connect PLC Inputs

Configure up to six PLC inputs to perform one of the
following options:
• Turn the system on/off
• Disable the system (turn off the pump)
• Enable/Disable individual channels (1 - 4)
1. Access the Electrical Enclosure. Follow the steps
on page 83.
2. Route a multi-conductor cable through an I/O cable
gland. See F . 12.
IG
F . 12: I/O Cable Gland Location
IG
3A7259C
3. Wire the desired PLC inputs to the System I/O
4. Set PLC Settings on the ADM. Follow the steps
207
Board on AMZ.
- Digital Inputs Wiring (0–30 VDC), page 22.
See F . 13 for reference.
IG
- Dry Contact Inputs Wiring (Open/Closed
Circuit), page 23. See F
on page 25.
Setup
. 14 for reference.
IG
21