Graco InvisiPac HM10 Instructions Manual page 69

Command
Interface - Description
Command ID
0x0731 -
Pattern Bead Offset
0x07F0
(8 guns, 24 beads per gun)
0x07F1 -
Pattern Bead Length
0x08B0
(8 guns, 24 beads per gun)
0x802F Line 1 Line Speed
0x8030 Line 2 Line Speed
0x8031 Line 1 Box Rate
0x8032 Line 2 Box Rate
0x8038 Pattern Controller Locked
0x8067 Pattern Controller State
0x8101 Active Program
0x8119 Trigger 1 Reverse Polarity
0x811A Trigger 2 Reverse Polarity See Trigger 1 Reverse Polarity
0x811B Trigger 3 Reverse Polarity Trigger 3 Reverse Polarity
0X811C Trigger 4 Reverse Polarity See Trigger 1 Reverse Polarity
0x811D Trigger 1 Line Select
0x811E Trigger 2 Line Select
0x881F Trigger 3 Line Select
0x8120 Trigger 4 Line Select
0x812F Line 1 Line Speed Mode
0x8130 Line 2 Line Speed Mode
0x8131 Line 1 Encoder Scaling
3A7259C
Variable Definition
Used to set the offset of a bead within the active
pattern (see Bead Offset Lookup Table to determine
the appropriate command for each bead/gun
combination). Values are in units of hundredths of
inches or tenths of millimeters (matched the ADM
distance units selected).
Used to set the length of a bead within the active
pattern (see Bead Length Lookup Table to determine
the appropriate command for each bead/gun
combination). Values are in units of hundredths of
inches or tenths of millimeters (matched the ADM
distance units selected). A value of 0 signifies a blank
or empty bead.
Line speed of Line 1. Values are in hundredths of
ft/min. or m/min (matches the ADM distance units
selected).
Line speed of Line 2. Values are in hundredths of
ft/min. or m/min (matches the ADM distance units
selected).
Boxes per minute on Line 1.
Boxes per minute on Line 2.
Value - Setting
0 - Pattern controller is not locked (able to dispense)
1 - Pattern controller is locked (not able to dispense)
Value - Setting
0 - Locked
1 - Disabled (via PLC Input)
2 - Off (Inactive)
3 - Active
Active pattern controller program.
Value - Setting
0 - Normal Polarity (signal asserted high/low indicates
unit present)
1 - Reverse Polarity (signal asserted high/low indicates
unit absent)
Value - Setting
1 - Trigger is used for Line 1
2 - Trigger is used for Line 2
See Trigger 1 Line Select
See Trigger 1 Line Select
See Trigger 1 Line Select
Value - Setting
1 - Fixed Line Speed Mode
2 - Encoder Mode
See Line 1 Line Speed Mode
Encoder scaling in thousandths of pulses/mm
(a value of 3333 corresponds to 3.333 pulses/mm)
Communications Gateway Module (CGM)
Read/Write
Read/Write
Read/Write
Read
Read
Read
Read
Read/Write
Read
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
69