Repair; Prepare Equipment For Service; Remove Equipment Covers - Graco InvisiPac HM10 Instructions Manual

Repair

Repair

Prepare Equipment for Service

DANGER
SEVERE ELECTRIC SHOCK HAZARD
This equipment can be powered by more than 240V.
Contact with this voltage will cause death or serious
injury.
• Turn off and disconnect all power before
disconnecting any cables and before servicing
equipment.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as skin injection, splashing
fluid and moving parts, follow the Pressure Relief
Procedure, page 26 before servicing the equipment.
The equipment surfaces and components can
become very hot. To avoid severe burns, wear
protective gloves and clothing that will insulate your
hands and body from the hot surfaces and adhesive
material.
Moving parts can pinch, cut, or amputate body parts.
To help prevent serious injury from moving parts, do
not operate equipment with the protective covers
removed.
1. Follow the Pressure Relief Procedure, page 26.
2. Drain the System. Follow the steps on page 30.
3. Flush the system if desired. See Flushing
Procedure, page 31.
4. Press the power button on the ADM screen to shut
down the system.
5. Disconnect power from the equipment.
82

Remove Equipment Covers

1. Prepare Equipment for Service. Follow the steps
on page 82.
2. Loosen the fasteners on the front melter cover (10)
to remove the front cover.
3. Remove the rear melter cover (224) as needed.
a. Disconnect the air filter (60).
b. Disconnect the air lines from the triple union
fitting (236).
c. Loosen the fasteners to remove the rear melter
cover (224).
236
10
F . 68: Equipment Covers
IG
224
60
3A7259C