Heated Hose And Applicator Connections - Graco InvisiPac HM10 Instructions Manual

Installation
Heated Hose and Applicator
Connections
The equipment surfaces and components can
become very hot. To avoid severe burns, wear
protective equipment, such as thermally insulated
gloves.
To help prevent serious injury from pressurized fluid,
such as skin injection, follow the Pressure Relief
Procedure, page 26 before connecting a hose to the
equipment.
Prepare For Connections
• Drain Before Using. Follow the steps on page 11.
• Follow the Pressure Relief Procedure, page 26 if
connecting to a system already in service.
Connect the Heated Hose to System
Connect up to four heated hoses starting with the
bottom connectors first. Follow your heated hose
manual for installation details. See Related Manuals,
page 3. See F . 4 for reference.
IG
1. Prepare For Connections. Follow the steps on
page 14.
2. Make an electrical connection (HC1) between the
system and the heated fluid hose.
a. Remove the electrical port cover (256) from the
electrical port.
b. Connect the hose electrical connector to a
system electrical port.
3. Make a fluid connection between the system and
the heated fluid hose.
a. Remove the fluid port plug (628).
b. Install a port connector (33, 34, or 67) on each
melter fluid outlet. Torque to 180 in-lb (20
N•m).
14
c. Connect the heated hose (BB) to the melter
fluid outlet starting with the bottom port. Use
two wrenches to torque hose to 300 in-lb (33
N•m).
NOTICE
Over-tightening the hose port connector will damage
the connector seal and cause fluid leaks. Do not
overtighten the port connector. Use two wrenches to
torque the hose to the melter pump.
Connect the Applicator to the Heated Hose
Install and configure the applicator following your
applicator instructions. See Related Manuals, page 3.
See F . 4 for reference
IG
1. Connect the hose fluid outlet to the applicator fluid
inlet (AL). Tighten the connector with a wrench.
2. Connect the heated hose and applicator electrical
connectors (HC2).
3A7259C