Table of Contents
Advertisement
Repair
F
. 95
IG
17. After waiting for the software to load, press the
check mark to restart the system.
F
. 96
IG
18. Once the software is installed, press the check
mark on the confirmation screen to continue.
F
. 97
IG
19. Remove the USB stick.
20. If using a 4 channel unit:
102
a. Remove the ADM and panel as described
above.
b. Disconnect the front panel USB bulkhead from
the right angle cable.
c. Plug the front panel USB bulkhead into the
USB hub.
d. Plug the USB hub into the right angle cable.
e. Install the ADM onto the unit as described
above.
Replace the Power Supply
Use Black Disconnect Handle Kit 17S164, page 122.
1. Access the Electrical Enclosure. Follow the steps
on page 83.
2. Disconnect power supply cables from the AMZ
(headers J3 and J21).
3. Loosen the power supply fasteners (212) and
washers (213) to remove the power supply (211)
from electrical enclosure.
4. Disconnect power supply cables from J3 and J21
plugs on the AMZ circuit board.
5. Make connections between new power supply
cables and J3 and J21 plugs. See Electrical
Schematics, page 105 for connections.
6. Mount the new power supply to the top of the
electrical enclosure with fasteners (212) and
washers (213).
7. Connect power supply cables AMZ (headers J3
and J21).
8. Install the ADM Screen. Follow the steps on page
83.
3A7259C
Advertisement
Table of Contents
Troubleshooting
