Table of Contents
Advertisement
5
Initial Screen Configuration
If the LED screen, cabinets, data flow and the number of cabinets loaded by Ethernet ports can meet the following
requirements, you can configure the screen via the device front panel menu; otherwise, screen configuration in VMP
will be your ideal choice.
Screen: The LED screen must be a regular screen.
Cabinet: The cabinets must be regular ones of the same size, and function well.
Data flow: The data must run in the same way for all Ethernet ports and the data flow must be one of the
followings. The starting position of the data flow is the first cabinet of Ethernet port 1, and the connections are
made in sequence according to the serial number of the Ethernet port.
Number of cabinets loaded by Ethernet ports: If n ports are used to load the cabinets, the number of cabinets
loaded by each of the first (n–1) ports must be the same and the integral multiple of the number of cabinet rows
or columns, and it must be greater than or equal to the number of cabinets loaded by the last port.
5.1 Quick Configuration via Front Panel Screen
5.1.1 Set Input Source
Select the desired input source and complete the related settings, such as resolution and frame rate. If the
resolutions of the input source and screen are the same, the image can be displayed pixel to pixel. A lower frame rate
may result in image flickering, while a higher frame rate helps stabilize the display image.
Note
Input source settings are required for screen configuration in the Send-Only Controller working mode and not
required in the All-In-One Controller mode.
On the main menu screen, choose Input Settings > Select Input to select a video source.
Figure 5-1 Select input source
Perform the corresponding operations for the input source according to the input source type. For the SDI sources,
please skip this step.
External input sources (HDMI1, HDMI2, DP)
www.novastar.tech
MX30 LED Display Controller User Manual
10
Advertisement
Table of Contents
