Fujitsu ORACLE M10-1 Installation Manual page 53

3.
Confirm the chassis mounting location in the rack.
a. Confirm the mounting location in the rack. If necessary, mark the location on
the supporting columns.
b. Confirm that the chassis mounting location is the same on the front and rear
columns.
c. Remove the inner rail from the slide rail.
Figure 3-2 Slide rail
Lock on inner rail
Inner rail
d. Pull out the inner rail by releasing the lock on the inner rail.
The inner rail is attached to the chassis in step 5.
e. Release the lock on the middle rail, and store it in the outer rail.
4.
Attach a slide rail to the rack.
a. Confirm the attachment direction of the slide rail.
The [R] mark on the slide rail indicates the right side, and the [L] mark
indicates the left side. The [FRONT] mark on the slide rail should be
positioned at the front of the rack.
b. From the front of the rack, attach the slide rail to the rear supporting column
of the rack. At this time, attach the slide rail brackets to the supporting
column of the rack, and align the protrusions on the slide rail with the holes
in the supporting column (attachment locations). Then, push back the slide
rail. (The latch clicks at this time.)
c. Pull the slide rail until the front of the rail meets the front of the front
supporting column of the rack. Align the protrusions on the slide rail with the
holes in the supporting column (attachment locations). Then, push the slide
rail to the rear of the rack until it clicks and locks. Confirm that the attached
Back of outer rail
Lock on outer rail
Outer rail
Middle rail
Chapter 3 Installing the System 43