Fujitsu ORACLE M10-1 Installation Manual page 17

Hide thumbs Also See for ORACLE M10-1:
Table of Contents

Advertisement

Table 1-4     Required work when updating the firmware from XCP 2043 or earlier to XCP
2044 or later (continued)
Yes
There is a logical
domain other than
the control domain
Table 1-5
indicates what information may need to be saved/restored when installing
or uninstalling the PCI expansion unit in a system with the firmware XCP 2044 or
later.
Table 1-5     Required work when installing or uninstalling the PCI expansion unit in the
system with the firmware XCP 2044 or later
PCI expansion unit
Current domain
mounted?
configuration
No
factory-default
(Install)
(Control domain
only)
No
There is a logical
(Install)
domain other than
the control domain
Yes
factory-default
(Install/remove)
(Control domain
only)
Yes
There is a logical
(Install/remove)
domain other than
the control domain
*1 Not required in XCP 2230 or later
Note - Execute the ldm list-constraints -x command to save it to an XML file, and execute the
ldm init-system -i command to restore it from an XML file. To display the information of
OpenBoot PROM environment, execute the printenv command at the ok prompt. For a
detailed procedure with these steps, see "1.7.3 How to Save/Restore the Logical Domain
Configuration Information and the OpenBoot PROM Environment Variable" in the PCI
Expansion Unit for Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Service Manual.
Required (XML file)
Required
Reconfiguring Oracle VM
Setting OpenBoot PROM
Server for SPARC config
environment variables
again
Not required
Not required
Required (XML file)
Required (*1)
Not required
Not required
Required (XML file)
Required (*1)
Chapter 1 Understanding the Installation Flow
7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ORACLE M10-1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Oracle sparc m10-1

Table of Contents