The XSCF-LAN ports support auto-negotiation only. Therefore, the communication
speed/mode for the XSCF-LAN ports cannot be configured.
Do not make a connection with a network switch or hub until you complete the
network setting for the XSCF. If a connection is made before the completion of the
setting, devices connecting with others may become unable to communicate, or
unauthorized login by a malicious third party to the XSCF of this chassis may be
unable to be prevented.
XSCF USB port (for field engineers)
■
Field engineers use this port to download information from the XSCF.
Other unit ports
GbE LAN port
■
The port is used to connect Oracle Solaris to the network. There are four ports.
Connection to the network is also possible through a LAN card, which is provided
by the customer, mounted in a PCI Express (PCIe) slot.
SAS port
■
This port is used to connect an external SAS device.
USB port
■
This is a general-purpose USB port. Use the port to connect an external USB DVD
device, etc.
Figure 2-12
shows the locations of external interface ports on the SPARC M10-1.
LAN port LEDs
LINK SPEED LED
■
This LED indicates the communication speed of the XSCF-LAN port and GbE
LAN port
(Figure
2-13).
ACT LED (green)
■
This LED indicates the communication state of the XSCF-LAN port and GbE LAN
port
(Figure
2-13).
Chapter 2 Planning and Preparing for System Installation
33
Need help?
Do you have a question about the ORACLE M10-1 and is the answer not in the manual?