Viewing The Connection Of An Output Port; Viewing Connections Of All Outputs; Viewing Mutes On All Outputs; Muting Specified Output - Lightware MX2-8x8-DH-4DPio-A User Manual

   
8. LW2 Programmers' Reference
8.4.4. Viewing the Connection of an Output Port
See the connected input port number of an output port.
Command and Response
ȩ {?<out>}
Ȩ (O<out>• I<input>)CrLf
Example
ȩ {?1}
Ȩ (O01 I03)
Input 3 is switched to output 1.
8.4.5. Viewing Connections of all Outputs
Viewing the output's connection results in different response length, because it depends on the device.
Command and Response #crosspoint
ȩ {VC•<layer>}
Ȩ (ALL<layer>•<O01>•<O02>)CrLf
Parameters
O01 shows the corresponding output's connection state.
Identifier Parameter description
<layer> Signal type of the layer
State letters
Letter
L Output is locked
M Output is muted
U Output is locked and muted
Example
ȩ {VC AV}
Ȩ (ALLA)
Ȩ (ALLV M01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 )
#switch
Parameter values
A: audio layer
V: video layer
AV: audio & video layer
State Example
L01
M01
U01
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
MX2 Standalone Matrix Switcher series – User's Manual
8.4.6. Viewing Mutes on all Outputs
Displays the mute states on all outputs.
Command and Response
ȩ {VM}
Ȩ (MUT<out>)CrLf
Parameters
All <out> indexes are one digit numbers, showing the mute state for the corresponding output. If
equals 0, the output x is unmuted. If
Example
ȩ {VM}
Ȩ (MUT 1 0 0 0 0 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 )
Output 1 and 7 is muted, the other outputs are not muted.
8.4.7. Muting Specified Output
Mute the <out> output. The output signal is turned off.
Command and Response
ȩ {#<out>}
Ȩ (1MT<out>)CrLf
Example
ȩ {#01}
Ȩ (1MT01)

ATTENTION! Muting does not change the state of the crosspoint, but disables the output itself. This way
the last connection can be easily restored with an unmute command. Switching a muted output does not
unmute the output.

INFO: Muting does not change the crosspoint's state, but disables the output itself. This way the last
connection can be easily restored with an unmute command.

INFO: Switching a muted output does not unmute the output.
<out> equals 1, the output x is muted.
#mute #lock #unmute #unlock
73
<out>