Table of Contents
Advertisement
4. Installation
4.1. Mounting Options
The matrix can be mounted in several ways by the supplied two rack ears. Allen head screws fix them to the
housing:
WARNING!
M4x8 size is the longest allowed screw for fixing the ears to the housing. A longer screw may
touch internal parts.
INFO:
The method is the same when the matrix would be mounted to a wall.
INFO:
More details about the accessories and the mounting can be found in the
Guide.
Standard Rack Installation (Default)
INFO:
All models can be mounted into the rack cabinet.
Two rack ears are supplied with the product, which are fixed on left and right side as shown in the picture.
The default position allows the mounting of the device as a standard rack unit installation.
ATTENTION!
Always use all four screws for fixing the rack shelf ears to the rack rail. Choose properly
sized screws for mounting. Keep a minimum of two threads left after the nut screw.
MX2 Standalone Matrix Switcher series – User's Manual
Mounting with Front and Rear Rack Ears
DIFFERENCE:
ATTENTION!
for this kind of installation, which can be purchased separately.
The matrix can be easily mounted under the desk by rack ears. This mounting option means the top of the
matrix is parallel with the base surface. Please do the following steps:
Step 1. Release and remove the fixing screws of the rack ears on the matrix (both sides).
Mounting Assembly
Step 2. Rotate the rack ears by 90° to the desired direction.
Step 3. Insert the screws into the holes and fix the front ears to the matrix.
Step 4. Fix the two additional rear ears (not supplied with the product) by the screws on both sides of the
Step 5. Fix the matrix through the holes of the rack ears to the desired surface (screws are not supplied).
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
Under-desk mounting is available for the 1U-high models.
Two rack ears are assembled on the matrix as default, thus you will need two more rack ears
matrix.
31
Advertisement
Table of Contents
Troubleshooting
