Switching An Input To An Output; Disconnecting The Output From Any Input; Switching An Input To All Outputs; Multiple Switching - Lightware MX2-8x8-DH-4DPio-A User Manual

   
9. LW3 Programmers' Reference
9.5.2. Switching an Input to an Output
Command and Response
ç CALL·/MEDIA/XP/VIDEO:switch(<in>:<out>)
æ mO·/MEDIA/XP/VIDEO:switch=OK
Example
ç CALL /MEDIA/XP/VIDEO:switch(I4:O1)
æ mO /MEDIA/XP/VIDEO:switch=OK
9.5.3. Disconnecting the Output from any Input
Command and Response
ç CALL·/MEDIA/XP/VIDEO:switch(0:<out>)
æ mO·/MEDIA/XP/VIDEO:switch=OK
Example
ç CALL /MEDIA/XP/VIDEO:switch(0:O1)
æ mO /MEDIA/XP/VIDEO:switch=OK
9.5.4. Switching an Input to All Outputs
Command and Response
ç CALL·/MEDIA/XP/VIDEO:switchAll(<in>)
æ mO·/MEDIA/XP/VIDEO:switchAll=OK
Example
ç CALL /MEDIA/XP/VIDEO:switchAll(I1)
æ mO /MEDIA/XP/VIDEO:switchAll=OK

TIPS AND TRICKS: All output ports can be disconnected by the '0' value:
CALL /MEDIA/XP/VIDEO:switchAll(0).
MX2 Standalone Matrix Switcher series – User's Manual
9.5.5. Multiple Switching
The whole crosspoint can be set by sending one command as follows.
Command and Response
ç CALL·/MEDIA/XP/VIDEO:switchMulti(<out1_source>;<out2_source>;...;<out8_source>)
æ mO·/MEDIA/XP/VIDEO:switchMulti=OK
The source is not required to be set on all output ports (see the Example2).
Parameters
The <out#_source>
the input port switched to the given output port.
Example1
ç CALL /MEDIA/XP/VIDEO:switchMulti(I1;I2;I3;I4;I5;I6;I7;I8)
æ mO /MEDIA/XP/VIDEO:switchMulti=OK
Example2
ç CALL /MEDIA/XP/VIDEO:switchMulti(I1;I2;;;I5)
æ mO /MEDIA/XP/VIDEO:switchMulti=OK
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
parameters mean the output ports one after the other. The value of the parameter shows
82