Table of Contents
Advertisement
3. Front Panel Control
3.1. Front Panel Buttons Operations
DIFFERENCE:
Some models have buttons on the front side (see the details about it in the
Comparison
table). They have the same functionality, only the number of source and destination buttons
is different.
Take / Autotake Mode
The router has two different switching modes: Take and Autotake. If the Take button is unlit, Take mode is active.
When the Take button continuously shines green, Autotake mode is selected. Press and hold the Take button
for two seconds to change between Take and Autotake modes.
#autotakemode
3.1.1. View Crosspoint State
The current switching status can be checked on the front panel by using the front panel buttons. The
crosspoint state is displayed slightly differently in Take or Autotake modes because of the different switching
methods.
INFO:
View mode does not mean that the router has to be switched in different modes, viewing and
switching can be done after each other, without pressing any special buttons.
View Current State in Take Mode
If the router is in Take mode, the user can verify both input and output connections. In Take mode no accidental
change can be done, unless Take button is pressed.
Press and release a source button. Now the selected source button and all destination buttons that are
currently connected to the selected source will light up. This informative display will remain active for three
seconds, then all buttons turn dark.
If every source, destination, and Take buttons are unlit (the unit is in Take mode, and no input was selected in
the last 3 seconds), press and release a destination button to see its current state. Now the source button that
is connected to the selected destination will light up.
MX2 Standalone Matrix Switcher series – User's Manual
Model
#button #crosspoint #switch #takemode
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
View Current State in Autotake Mode
In Autotake mode only states of destinations can be viewed.
Press and release the required destination button. Now the source button that is connected to the selected
destination will light up.
3.1.2. Switching Operations
Switching in Take Mode
Take mode allows the user to connect or disconnect multiple outputs to an input at once. This mode is
useful when the time delay is not allowed between multiple switching. The commands are only realized
when the Take button is pressed.
Step 1. First, press and release the desired source button. The pressed source button and all destination
buttons that are currently connected to the source light up.
Step 2. Press and release the desired destination buttons that have to be (dis)connected to/from the selected
source. The preselected destination buttons will blink. If no button is pressed for three seconds, the
buttons will turn dark.
Step 3. Press and release Take button; the selected input is switched to the selected output(s).
20
Advertisement
Table of Contents
Troubleshooting
