Updating Via Gui - Lightware MX2-8x8-DH-4DPio-A User Manual

   
10. Firmware Update
10.6. Updating Via GUI
To update the desired device(s) via the Graphical User Interface follow, these steps.
Step 1. Select the Firmware Package
Click on the Choose Package File button and navigate to the location where
the LFP2 file was saved. When you click on the name of package, the
preview of the release notes are displayed in the right panel.
After the package file is loaded, the list is filtered to show the compatible devices only. The current firmware
version of the device is highlighted in orange if it is different from the version of the package loaded.

INFO: If you start the update by double-clicking on the LFP file, the screen above will be loaded right away.
MX2 Standalone Matrix Switcher series – User's Manual
CHOOSE PACKAGE FILE
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
The Meaning of the Symbols
Show The log about the updating process of the device

details can be displayed in a new window.
Service The device is in bootload mode. Backup and restore
mode cannot be performed in this case.
Step 2. Select the desired devices for updating.
Select the devices for updating; the selected line will be highlighted in green.
If you are not sure which device to select, press the Identify me
for 10 seconds. The feature helps to find the device physically.
Step 3. Check the update parameters

DIFFERENCE: The appearing settings are device-dependent, and can be different device by device.
Clicking on the Update Options button, special settings will be available, such as:
▪ Creating a backup about the configuration,
▪ Restore the configuration or reloading the factory default settings after the firmware update,
Uploading the default Miniweb (if available)
▪
Please arrange the settings carefully.
Step 4. Start the update and wait until it is finished
Click on the Start Update button to start the procedure. The status is shown in
percent in the right side of the device line, and the overall process in the bottom
progress bar. The update takes about 10-12 minutes to finish, which is independent
of the number of the updated devices, since the updates are processed simultaneously.
INFO:
The device might reboot during the firmware update
procedure.
The log about the updating process can be displayed in a
new window by pressing the  button. When the progress bar
reaches 100% (Done is displayed at all devices), the update of
all devices are finished successfully and a message appears;
you can close the software.
Step 5. Wait until the unit reboots with the new firmware
Once the firmware update procedure is completed, the device is rebooted with the new firmware. Shutting
down and restarting the device is recommended.
106
button. It makes the front panel LEDs blink

UPDATE OPTIONS
#builtinweb #miniweb #web
START UPDATE