Table of Contents
Advertisement
7. Software Control – Lightware Device Controller
7.10. Advanced View
Advanced view is the surface for displaying the LW3 protocol tree. Commands and specific parameters
(which are not available on the graphical user interface of the LDC) can be run and set by the controlling
tools.
#advancedview #terminal
1
2
7
3
4
5
6
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
MX2 Standalone Matrix Switcher series – User's Manual
1
LW3 protocol help
2
Terminal window
Protocol tree
3
4
Edit mode
Node list
5
Warning mode
6
7
Command line
Pushing the button results in a help window opening, which describes the
most important information about LW3 protocol commands in HTML format.
Commands and responses with time and date are listed in this window. A sent
command starts with a '>' character, while a received response starts with a
'<' character. The color of each item depends on the type of the command
and the response. The content of the window can be emptied with the Clear
button. If the Autoscroll option is ticked, the list is scrolled automatically when
a new line is added.
LW3 protocol tree; select an item to see its content.
The default appearance is the read-only mode. If you want to modify the
values or parameters, tick the option. You will be prompted to confirm your
selection.
Correspondent parameters and nodes are shown that are connected to the
selected item in the protocol tree.
Manual button:
Manual (short description) of the node can be called and
displayed in the terminal window.
Set button:
Saves the value/parameter typed in the textbox.
Call button:
Calls the method, e.g. reloads factory default settings.
If this is checked, a warning window pops up when you enable Edit mode.
Type the desired command and execute it by the Send button. Clear all current
commands and responses in the Terminal window with the Clear button.
67
Advertisement
Table of Contents
Troubleshooting
