View The Connection Of An Output Port; View Connections Of All Outputs; View Mutes On All Outputs; Mute Specified Output - Lightware MX2-4x4-HDMI20-CA User Manual


  
7. LW2 Programmers' Reference
8.4.4. View the Connection of an Output Port
See the connected input port number of an output port.
Command and Response
ȩ {?<out>}
Ȩ (O<out>• I<input>)CrLf
Example
ȩ {?1}
Ȩ (O01 I03)
Input 3 is switched to output 1.
8.4.5. View Connections of all Outputs
Viewing the output's connection results in different response length, because it depends on the device.
Command and Response #crosspoint
ȩ {VC•<layer>}
Ȩ (ALL<layer>•<O01>•<O02>)CrLf
Parameters
O01 shows the corresponding output's connection state.
Identifier Parameter description
<layer> Signal type of the layer
State letters
Letter
L
M
U
Example
ȩ {VC AV}
Ȩ (ALLA)
Ȩ (ALLV M01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 01 )
#switch
Parameter values
A: audio layer
V: video layer
AV: audio & video layer
State Example
Output is locked L01
Output is muted M01
Output is locked and muted U01
MX2-HDMI20 series – User's Manual
8.4.6. View Mutes on all Outputs
Displays the mute states on all outputs.
Command and Response
ȩ {VM}
Ȩ (MUT<out>)CrLf
Parameters
All <out>
equals 0 the output x is unmuted. If
Example
ȩ {VM}
Ȩ (MUT 1 0 0 0 0 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 )
Output 1 and 7 is muted, the other outputs are not muted.
8.4.7. Mute Specified Output
Mute the
Command and Response
ȩ {#<out>}
Ȩ (1MT<out>)CrLf
Example
ȩ {#01}
Ȩ (1MT01)

ATTENTION!
the last connection can be easily restored with an unmute command. Switching a muted output does not
unmute the output.
INFO: Muting does not change the crosspoint's state but disables the output itself. This way the last
connection can be easily restored with an unmute command.
INFO: Switching a muted output does not unmute the output.
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
indexes are one digit numbers, showing the mute state for the corresponding output. If
<out> equals 1, the output x is muted.
<out> output. The output signal is turned off.
#mute #lock #unmute
Muting does not change the state of the crosspoint but disables the output itself. This way
72
<out>
#unlock