Edid Menu; Sources And Destinations - Lightware MX2-8x8-DH-4DPio-A User Manual

   
7. Software Control – Lightware Device Controller
7.8. EDID Menu
Advanced EDID Management can be accessed by selecting the EDID menu. There are two panels: left one
contains Source EDIDs, right one contains Destination slots where the EDIDs can be emulated or copied.
#edid
MX2 Standalone Matrix Switcher series – User's Manual
Control buttons
7.8.1. Sources and Destinations
The EDID memory consists of four parts:
▪
▪
▪
▪
There are two types of emulation: static and dynamic.
▪
▪
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
Exporting an EDID
(save to a file)
Importing an EDID
(load from a file)
Display EDID
Summary window
Opening Advanced EDID
Editor with the selected EDID
Opening Easy EDID Creator
Factory EDID list (F1-F148) the pre-programmed EDIDs, see the
Dynamic EDID list (D1-D8): the EDID of the last attached display device. The matrix stores the last EDID
from the previously connected sink on each output port. Thus, an EDID can be shown even if there is
no device is connected to the output port at that moment.
User memory locations (U1 – U100): they can be used to save custom EDIDs. Any EDID from the User/
Factory/Dynamic EDID lists can be copied to the user memory.
Emulated EDID list (E1-E8): the currently emulated EDID for the input. The source column displays
the memory location that the current EDID was routed from. The source reads the EDID from the
Emulated EDID memory on the input port.
Static EDID emulation: an EDID from the Factory or User EDID list is selected. Thus, the Emulated EDID
remains the same until the user emulates another EDID.
Dynamic EDID emulation: it can be enabled by selecting D1-D8 EDID memory. The attached monitor's
EDID is copied to the input; if a new monitor is attached to the output, the emulated EDID is changed
automatically.
61
Executing EDID emulation or
copying (Transfer button)
Deleting EDID (from User
memory)
Selecting all memory places
in the right panel
Selecting none of the memory
places in the right panel
Factory EDID List in the Appendix section.