Lldp Source-Mac Vlan - H3C IE4300 Command Reference Manual

Use
undo lldp notification remote-change enable
Syntax
In Layer 2 Ethernet interface view:
lldp [ agent { nearest-customer | nearest-nontpmr } ] notification
remote-change enable
undo lldp [ agent { nearest-customer | nearest-nontpmr } ] notification
remote-change enable
In Layer 2 aggregate interface view:
lldp agent
remote-change enable
undo lldp agent { nearest-customer | nearest-nontpmr } notification
remote-change enable
Default
LLDP trapping is disabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies an LLDP agent type. If you do not specify an agent type in Ethernet, the command
agent
enables LLDP trapping for nearest bridge agents.
nearest-customer
nearest-nontpmr
Examples
# Enable LLDP trapping for the nearest customer bridge agent on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp agent nearest-customer notification remote-change
enable

lldp source-mac vlan

Use
lldp source-mac vlan
of a VLAN interface.
Use
undo lldp source-mac vlan
Syntax
lldp source-mac vlan vlan-id
undo lldp source-mac vlan
Default
The source MAC address of LLDP frames is the MAC address of the interface.
{ nearest-customer
: Specifies nearest customer bridge agents.
: Specifies nearest non-TPMR bridge agents.
to set the source MAC address of LLDP frames to the MAC address
to restore the default.
| nearest-nontpmr
38
to disable LLDP trapping.
} notification