6.1.3
Top Panel
(22) VR1 Volume
For setting the rated speed of the STP pump.
This volume is normally made ineffective (see Section 9.2, "Setting the Rated
Speed").
(23) DSW-B Dip Switches
For optional settings.
Figure 6.3 shows the functions and the factory settings of the dip switches.
<No.1 switch (Rated speed setting)>
Rated speed can be changed by switching this switch "ON". (see Section 9.2, "Setting
the Rated Speed")
<No.4 switch (Remote input signal change)>
It is valid with only the specification of remote connector CON4 (special accessory).
The state of input terminal and connector can be changed by this switch "ON/OFF"
operation.
No.4 switch
ON
OFF
Front Panel Side
Remote input signal
Remote connector
CON4
Valid
Invalid
(22) (23)
Figure 6.3 STP Control Unit Top Panel
6-5
STP-L301/L451 Series Instruction Manual
Remote terminal block
TB2
Invalid
Valid
Expanded view of
DSW-B switch
(setting at delivery)
8 7 6 5 4 3 2 1 ON
"ON" only
with CON4.