Installation; Unpacking; Front Panel; Stc-U Front Panel - Edwards STP-XF1313 Series Instruction Manual

3

INSTALLATION

3.1

Unpacking

Check outer package for damage and that the delivery note corresponds to the purchase order. If the
STC-U is damaged, contact Edwards or their distributor.
Note : It is recommended to keep the packaging materials, such as the corrugated fibreboard
container and cushioning material for possible re-use.
3.2

Front panel

7
No Descriptions
1 POWER LED
2 VALVE 1 LED
3 VALVE 2 LED
4 HEATER 1 LED
5 HEATER 2 LED
6 POWER breaker
7 Cover (for maintenance only) Do not open this cover. Used only by Edwards service
STC-U eTMS unit
2 3 4
5
Figure 11 - STC-U front panel
(Green/Orange/Red LED) illuminates the STC-U operation
status. Green LED illuminates during normal operation.
Refer to Table 5 for Orange flash, Red flash, and Red light.
(Green LED) turns on when VALVE 1 connected to the
connector X4 (1 pin and 2 pin) is commanded to open the
valve.
(Green LED) turns on when VALVE 2 connected to the
connector X4 (3 pin and 4 pin) is commanded to open the
valve.
(Green LED) turns on when the HEATER 1 connected to the
X5 HEATER OUT1 connector is commanded to heat up.
(Green LED) turns on when the HEATER 2 connected to the
X7 HEATER OUT2 connector is commanded to heat up.
Main power circuit breaker.
(NOT switch the output of X2 AC OUT connector)
personal.
Table 1 - STC-U front panel functions
1
6
Function
3
MT-92E-B01-D
Page 13