Figure 8.2 I/O Tb2 Remote Input Signal Terminal Block - Edwards STP-L301 Series Instruction Manual

STP-L301/L451 Series Instruction Manual
I/O TB2:
Remote Input Signal Terminal Block
+12V
Rated Current
Approx. 1mA
Approx. 1mA
Approx. 1mA

Figure 8.2 I/O TB2 Remote Input Signal Terminal Block

◇ I/O TB2 fuses F1 to 4 are on the substrate in the circuit.
For their replacement, contact service office.
◇ The input current of remote input signal is approximately 1mA. Make sure the
minimum applicable load of the relay contact when the remote operation with the
relay.
Approx. 330 ohms
+12V
Approx. 10 ohms
0V
Fuse
COM
F1 250VAC 0.1A
STOP
F3 AC250V 0.1A
START
F4 AC250V 0.1A
RESET
F2 AC250V 0.1A
8-6
In case of 1) in Table 8.4
In case of 2) in Table 8.4
In case of 3)
in Table 8.4
25VAC
12 to 48VDC