HPE ProLiant DL380 Gen10 Plus User Manual page 14

Item Item Description Description
4 Power On/Standby button
and system power LED
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
3
Facility power is not present, the power cord is not attached, no power supplies are installed, power supply failure has occurred, or
the power button cable is disconnected.
12 LFF front panel LEDs and buttons 12 LFF front panel LEDs and buttons
Item Item Description Description
1
1 UID button/LED
1
2 NIC status LED
Status Status
Solid green = System on
1
Flashing green (1 Hz/cycle per sec) =
Performing power on sequence
Solid amber = System in standby
Off = No power present
Status Status
Solid blue = Activated
Flashing blue:
1 Hz/cycle per sec = Remote management
or firmware upgrade in progress
4 Hz/cycle per sec = iLO manual reboot
sequence initiated
8 Hz/cycle per sec = iLO manual reboot
sequence in progress
Off = Deactivated
Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network
active
Off = No network activity
3
Front panel LEDs and buttons 14