HPE ProLiant DL380 Gen10 Plus User Manual page 68

If a static IP address is assigned, use that IP address.
The default login credentials are located on the serial label pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
Power on the server Power on the server
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
Update the firmware Update the firmware
6. Using the SPP, update the following:
System ROM
Storage controller
Network adapters
Intelligent Provisioning
Set up storage Set up storage
7. Do one of the following:
To configure the server to boot from a SAN, see the following guide:
https://www.hpe.com/info/boot-from-san-config-guide https://www.hpe.com/info/boot-from-san-config-guide
If a smart array controller is installed:
For SR controllers, use HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator.
For MR controllers, use the UEFI System Configuration to create arrays.
IMPORTANT: IMPORTANT:
MR controllers are not supported by Intelligent Provisioning or Smart Storage Administrator.
NOTE: NOTE:
Before installing an OS with a MR controller, configure the drives. If the drives are not configured, the OS will
not detect the drives during installation. For more information, see the MR user guide for your controller.
If no controller is installed, do one of the following:
AHCI is enabled by default. You can deploy an OS or virtualization software.
Disable AHCI, enable software RAID, and then create an array:
a. From the boot screen, press F9 to run UEFI System Utilities.
b. From the UEFI System Utilities screen, select System Configurations > BIOS/Platform Configuration (RBSU) > Storage
Options > SATA Controller Options > Embedded SATA configuration > SmartRAID SW RAID Support
c. Enable SW RAID.
d. Save the configuration and reboot the server.
e. Create an array:
i. From the boot screen, press F9 to run UEFI System Utilities.
ii. From the UEFI System Utilities screen, select System Configuration > EmbeddedStorage: HPE SR100i Gen10+ SW
RAID > Array Configuration > Create Array
Deploy an OS or virtualization software Deploy an OS or virtualization software
8. Do one of the following:
Run Intelligent Provisioning to deploy an OS.
Set up the server 68