Installing A Rear 2 Sff Sas/Sata Drive Cage In The Primary Or Secondary Riser - HPE ProLiant DL380 Gen10 Plus User Manual

Installing a rear 2 SFF SAS/SATA drive cage in the primary or secondary riser

Installing a rear 2 SFF SAS/SATA drive cage in the primary or secondary riser
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
The components included with the hardware option kit
The front drive bays are fully populated with 12 LFF or 24 SFF drives.
High-performance fans are installed in all fan bays.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Do one of the following:
For primary bays, remove the riser cage.
For secondary bays, remove the rear wall blank.
Installing a rear 2 SFF SAS/SATA drive cage in the primary or secondary riser 170