Installing A Midplane Drive Cage - HPE ProLiant DL380 Gen10 Plus User Manual

Installing a midplane drive cage

Installing a midplane drive cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that the components included with the hardware option kit are available.
About this task About this task
Observe the following:
A 1U heatsink is required for each processor when installing this option.
If you have a TPM, install it prior to this option.
If you have a type-a controller, install it prior to this option.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the air baffle .
The air baffle is no longer needed. The drive cage acts as an air baffle for the server.
6. Remove all riser cages.
Installing a midplane drive cage 167