HPE ProLiant DL380 Gen10 Plus User Manual page 202

Preparing the server Preparing the server for installation
Procedure Procedure
1. Observe the following warnings:
WARNING: The front panel Power On/Standby button does not shut off system power. Portions of the power supply WARNING:
and some internal circuitry remain active until AC power is removed.
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from the server:
For rack and tower servers, remove the power cord.
For server blades and compute modules, remove the server blade or compute module from the enclosure.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system WARNING:
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center website
(https://www.hpe.com/support/hpesc https://www.hpe.com/support/hpesc). To update the system ROM, follow the instructions on the website.
3. Power down the server.
a. Shut down the OS as directed by the OS documentation.
b. To place the server in standby mode, press the Power On/Standby button. When the server enters standby power mode, the
system power LED changes to amber.
c. Disconnect the power cords (rack and tower servers).
4. Do one of the following:
Depending on your product, extend or remove the server from the rack.
Remove the server from the enclosure.
5. If removed, place the server on a flat, level work surface.
6. Remove the access panel.
7. Remove any options or cables that might prevent access to the TPM connector.
8. Proceed to "Installing the TPM board and cover."
for installation
Preparing the server for installation 202