Installing An M.2 Drive - HPE ProLiant DL380 Gen10 Plus User Manual

Installing an M.2 drive

Installing an M.2 drive
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-10 Torx screwdriver
About this task About this task
This procedure is for replacing M.2 drives located on an expansion card, riser, or the system board only. Do not use this procedure to
replace uFF drives.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the riser cage.
6. Install the drive.
Results Results
The installation is complete.
Installing an M.2 drive 131