3.10 Starting with the immobilizer (option)
27
Fig. 91: Immobilizer
1
0
2
19
Fig. 91: Preheating start switch
Fig. 91: Indicator lights
OM 25-3503 us – Edition 4.1 * 2503_3503b330.fm
After you have completed the starting preparations:
☞
Approach the transponder key to about 2 cm from the emitter/receiver unit 27
☞
The machine can be started as soon as the red indicator light 26 goes out
26
☞
Insert the starting key in the preheating start switch 19 within 30 seconds and
☞
Turn the starting key at least to position "1"
☞
Check whether all indicator lights illuminate:
☞
Replace malfunctioning indicator lights immediately.
☞
Turn the starting key to position "2" and hold it in this position for about 5 seconds
➥
The intake air is preheated
☞
Turn the starting key to position "3" and hold it in this position until the engine starts
➥
If the engine does not start after 10 seconds
☞
Interrupt the start procedure and try again after about 1 minute
3
➥
If the engine still does not start after the second try
☞
Contact a Wacker Neuson service center for troubleshooting
➥
As soon as the engine runs:
☞
Release the starting key
Operation
3-23