Regeneration Push Button - Wacker Neuson 2503 Operator's Manual

Operation

Regeneration push button

A
Fig. 256 Fig. 256
B C
Fig. 257
3-112
Push button A is located on the control element on the left.
Push button A is in the middle position and can be pressed either upward or downward,
1
but does not engage.
The automatic regeneration mode is preset if the engine is stopped for at least 30 sec-
onds.
2
Push button functions
1: disable/interrupt/re-enable regeneration
2: automatic regeneration mode (middle position)
3
3: re-activation of automatic regeneration
Indicator lights
Three indicator lights indicate the regeneration status.
B: Regeneration required
This indicator light illuminates if the contamination level reaches a specific value.
D
C: Increased exhaust-gas temperature
This indicator light illuminates during regeneration. It goes out once regeneration is over
and the system has cooled down.
D: Regeneration disabled/interrupted
This indicator light illuminates if the push button is pressed to position 1.
OM 25-3503 us – Edition 4.1 * * 2503_3503b340.fm