Engine Lubrication System; Checking The Oil Level - Wacker Neuson 2503 Operator's Manual

5.4 Engine lubrication system

Checking the oil level

max
min
Fig. 267: Checking the oil level
max
min
B
Fig. 268: Checking the oil level
OM 25-3503 us – Edition 4.1 * 2503_3503b510.fm
Environment!
Collect the fuel/water mixture as it drains with a suitable container and dispose
of it in an environmentally friendly manner.
NOTICE
If the engine oil level is too low or if an oil change is overdue, this can cause
Engine damage and loss of output!
• Have the oil changed by a Wacker Neuson service center
– see chapter 5.17
see chapter
Information!
Check the oil level once a day.
We recommend checking it before starting the engine. After stopping a warm
engine, wait at least 5 minutes before checking.
☞
Proceed as follows:
•Park the machine on level ground
•Stop the engine!
•Raise the control lever base
•Let the engine cool down
•Open the engine cover
•Clean the area around the oil dipstick with a lint-free cloth
•Oil dipstick A (Tier III) or B (Tier IV)
☞
Pull it out
A
☞
Wipe it with a lint-free cloth
☞
Push it back in as far as possible
☞
Withdraw it and read off the oil level
☞
However if necessary, add oil at the latest when the oil reaches the MIN mark on the oil
dipstick A or B
Maintenance plan (overview) on page 5-38 (Tier III) or
Maintenance plan (Tier IV) on page 5-43 (Tier IV)
Maintenance
–
5-5