Operation
Starting with the drive interlock (option)
E
L
Abb. 48: Immobiliser
1
0
25
Abb. 49: Preheating start switch
Abb. 50: Indicator lights
Starting with the drive interlock – internal transponder (option) (from serial number AG00673)
A
2 x
Abb. 51: Indicator lights
3-14
After you have completed the starting preparations:
☞
Approach the transponder key to about 2 cm from the emitter/receiver unit E
☞
The machine can be started as soon as the red indicator light L goes out
☞
Now insert the ignition key within 30 seconds in the preheating start switch 25 and turn
the ignition key at least in position „1"
☞
Check whether all indicator lights illuminate:
☞
Replace malfunctioning indicator lights immediately.
☞
Turn the starting key to position "2" and hold it in this position for about 5 seconds
➥
The intake air is preheated
☞
Turn the starting key to position "3" and hold it in this position until the engine starts
2
➥
If the engine does not start after 10 seconds
☞
Interrupt the start procedure and try again after about 1 minute
3
➥
If the engine still does not start after the second try
☞
Contact a Wacker Neuson service center for troubleshooting
➥
As soon as the engine runs:
☞
Release the starting key
A = operator's key (blue key)
For starting the machine. Scope of delivery includes 2 keys.
B
B = master key (red key)
Notice!
Store the master key in a safe place. It is only used for coding new keys.
1 x
All keys are deleted if the key remains in position 1 for more than 20 seconds. A
new immobilizer must be installed if the master key is lost.
BA 1404 en – Edition 2.7 * * 1404b330.fm