Note
When assigning two to four DME channels to one key, the selected DME
channels must be successive.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
You can check the DME operating status in the Status menu (see page 504).
Selecting the video signal for the DME assigned to a key
For the operating procedure, see"Selecting the video signal for a DME
assigned to a key" (page 359).
Assigning a DME output signal as a monitor signal
1
In the Processed Key menu, press [Monitor].
The Monitor menu appears.
2
Press [Monitor Set], turning it on.
3
In the <DME Select> group, select the DME channel (DME1 to DME4) to
be used.
This assigns the selected DME output to DME MON V and DME MON K.
The colors with which [DME1] to [DME4] are lit show the key assignment
status.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Off: Unassigned DME
Specifying the Key Output Destination
Using the key processed keyer signals (external processed key)
To select the key processed keyer key fill and key source signals on the AUX
buses, press [Ext Proc Key], turning it on, in the Processed Key menu.
This assigns the key fill and key source signals for M/E-1 key 1 to reentry
signals PROC V and PROC K.
Key Setting Operations Using Menus
355