Table of Contents
Advertisement
File Management
Saving and Recalling Files
Saving and Recalling Files
FieldFox State files are intended to be recalled on the same instrument
model on which they were saved. Sometimes you may able to recall them
within model families. An error will result when trying to recall a state file
that was saved on a different model family.
The FieldFox model families are:
— N991x (VNA/SA) model family
— N992x (VNA) model family
— N993x (SA) model family
— N995x (VNA/SA) model family
— N996x (SA) model family
Save Files
How to Save a File
— Press Save/Recall 9.
— Then Save.
— At the top of the current 'labeler' screen (see following image) check the
— Then use the labeler to specify a filename.
If you are having difficulty saving to a USB flash drive, it may be a timing issue.
The turn-around time for "file open, write data, file close" to a USB drive is much
longer than to FieldFox's internal memory. Alternative methods are:
1. Save your content to the FieldFox's internal memory; and then move your files
2. Save your data to the FieldFox's internal memory, then move the data to a PC
17- 2
File Type to save and Device (Internal, USB, Storage Card) to which the file
is saved. Learn how to change these settings in
Device" on page
17-5.
off to a USB flash drive using FTP SCPI programming. Refer to
FieldFox
FieldFox Programming Guide
and to the
using a binary block transfer, and delete the data from the FieldFox's internal
An example for transferring an image:
memory.
http://na.support.keysight.com/fieldfox/help/Programming/webhelp/
Examples/Transfer_Image_to_PC.htm. Please note that the receiving
computer program needs to be able to handle the binary block transfer. See
also
FieldFox Programming Guide
"Set File Type and Select
.
.
Keysight N9912-90001 User's Guide
Using FTP with
Advertisement
Table of Contents
