Table of Contents
Advertisement
SA (Spectrum Analyzer) Mode
SA Mode Settings
How to create a Cable file from an S21 (NA mode) measurement
1. Measure the S21 of a cable.
2. Use Manage Folders to change the active folder to CABLES. Learn how in
3. While in NA mode, save the measurement as a *.csv file. Learn how in
4. In SA mode, select Corrections, then recall the *.csv file for correction.
Tune & Listen (AM/FM)
The Tune & Listen feature can be used to identify an interfering AM or FM
signal.
The demodulated AM or FM signal can be heard through the internal speaker
or through headphones using the 3.5 mm jack located on the FieldFox side
panel.
The Tune & Listen tuner is separate from the SA display. This allows you to
listen to one frequency while displaying a different range of frequencies. The
Tune & Listen measurement alternates between normal SA sweeps for the
display and performing audio demodulation at the Tune Frequency. See the
Listen Time setting for more information.
Figure 8-3 Tune & Listen ON
In the graphic above, Tune & Listen ON with Tune Frequency is indicated by a
vertical bar (highlighted).
8- 16
"Manage Folders" on page
to Save a File" on page
17-8.
17-2.
Keysight N9912-90001 User's Guide
"How
Advertisement
Table of Contents
