Preset; How To Preset The Fieldfox; User Preset - Keysight Technologies FieldFox N9912A104 User Manual

System Settings

Preset

Preset
The Preset key restores the FieldFox measurement settings to a known
condition. You can preset the entire instrument, or just the current Mode (CAT,
SA, Power Meter, NA).
When Preset, the FieldFox CalReady calibration is recalled for use in CAT and
NA Modes. Learn more in
page
The following settings always survive Preset and Mode Preset:
— External Reference state (see
— SA Units (see
— SA Correction states (see
— VVM Display Resolution (see
— Marker Peak Excursion and Threshold (see
— Volume Control

How to Preset the FieldFox

— Press Preset.
— Then choose one of the following:

User Preset

User Preset allows you to store custom settings for each mode, then recall the
settings when the Preset key is pressed. Your custom settings are saved to a
standard State file (UserPreset.sta). However, unlike State files, calibration
data is NOT saved. Learn more about State files in
Device" on page
Keysight N9912-90001 User's Guide
— SA Mode ONLY – With
press also causes a single sweep.
— Continuous ON OFF
setting when battery power is not critical.
7-3.
page 18-15)
"Scale and Units" on page
page 16-10)
— Preset Returns ALL Modes to the factory default settings.
— Mode Preset Returns only the current Mode to the factory default
settings. The current settings for all other Modes remain.
17-5.
Continuous OFF
Makes continuous sweeps. This is the typical
"Preset Calibration (also known as CalReady)" on
"Frequency Reference Source" on
8-8)
"Field Strength Measurements" on page
"Display Resolution" on page
"What Is a 'Peak'" on
each successive Run/Hold
8-12)
14-5)
"Set File Type and Select
18- 3