Editing A Register Name; Recalling A Measurement Setup; Figure 2-35 File Name Pop-Up - Keysight Technologies N432A User Manual

Editing a register name

Procedure
Use the following steps to edit the name of a register.
1 Press
2 Use the up/down arrow key to select the required register and press

Figure 2-35 File name pop-up

3 Use the up/down arrow key to modify the character on which the
4 Use the left/right arrow key to move to other characters.
5 Use
6 To confirm your selection, press

Recalling a measurement setup

Procedure
Use the following steps to recall a measurement setup.
1 Press
2 Use the up/down arrow key to select the required register, and press
3 The N432A will prompt you to press
N432A User's Guide
> Save/Recall
Edit Name . The current register name will be displayed as shown in the
following example.
cursor is currently positioned.
and
Insert Char
>
Save/Recall
. The softkey is disabled (grayed out) when an unused
Recall Recall
register is selected.
.
as required.
Delete Char
.
Enter
.
Confirm
Operating Information
to proceed.
2
67