Table of Contents
Advertisement
VVM (Vector Voltmeter) Mode - Option 308
VVM Mode Settings
VVM Mode Settings
Select VVM Mode before making any setting in this section.
How to select VVM Mode
— Press Mode.
— Then VVM.
Measurement Selection
How to select a VVM Measurement
— Press Measure 1.
— Then choose from the following:
Frequency Selection
VVM measurements are made at a single CW frequency.
How to set Frequency
Frequency can be set to 1 Hz resolution.
— Press Freq/Dist .
— Then Frequency.
— Enter a value using the numeric keypad, the
— After using the
— After using the keypad, select a multiplier key. Learn about multiplier
14- 4
—
1-Port Cable Trimming
make this measurement in
on page
14-9.
—
2-Port Transmission
to make this measurement in
on page
14-11.
knob.
arrows or the rotary knob, press Enter. The increment
setting of the arrows is based on the current span and can NOT be changed
in VVM Mode.
abbreviations
in"Multiplier Abbreviations" on page
1-port reflection measurement. Learn how to
"1-Port Cable Trimming Measurements "
2-port transmission measurement. Learn how
"2-Port Transmission Measurements"
Keysight N9912-90001 User's Guide
arrows, or the rotary
2-14.
Advertisement
Table of Contents
