Table of Contents
Advertisement
SA (Spectrum Analyzer) Mode
Channel Measurements
— Trace State is set to Average.
— Detector is set to Average.
— Count is set to 15.
Any of these settings can be changed manually during a Channel
measurement. Learn more about these settings starting in
page
To change Averaging:
— Press Meas Setup 4.
— Then
— Then
— Enter a value between 1 and 10,000 using the numeric keypad,
arrows, or the rotary knob.
— Press Enter.
Traces
Only one measurement trace can be displayed in Channel Measurements.
Channel Power (CHP)
Channel Power measures total power over the specified Integrated BW. The
Integration Bandwidth (IBW) can be adjusted to measure the power over
multiple channels.
8- 38
8-29.
Average Enable ON OFF
Average
Count.
OFF effectively sets the Average Count to 1.
Keysight N9912-90001 User's Guide
"Average Type" on
Advertisement
Table of Contents
