Setting Up A Measurement; Connect The Analyzer To The Target System - Agilent Technologies 16712A Help Manual

Chapter 1: Agilent Technologies 16712A 128K Sample Logic Analyzer

Setting Up a Measurement

Setting Up a Measurement

After you have connected the logic analyzer probes to your target
system, (see page 10) there are five basic steps for any measurement.
1. "Define the Type of Measurement" on page 11
2. "Set Up the Bus Labels" on page 13
3. "Define Trigger Conditions" on page 14
4. "Run the Measurement" on page 15
5. "Examine the Data" on page 16
If you load a configuration file, it will set up the logic analyzer and
trigger. For your particular measurement, you may need to change
some settings.
See Also
"Making a Basic Timing Measurement" on page 22
"Making a Basic State Measurement" on page 18
Measurement Examples (see the Measurement Examples help volume)
Making Basic Measurements for a self-paced tutorial

Connect the Analyzer to the Target System

Before you begin setting up a measurement, you need to physically
connect the logic analyzer to your target system. Attach the pods in a
way that keeps logically related channels together and be sure to
10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Refine measurement by repeating steps 3 - 5.